. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION AND REAR BRAKE COOLING OIL FILTER ELEMENT WARNING to release the internal 4 - 76 Immediately afte r the engi ne is stopped, the parts and oil a re at high temperature, and th ere is danger th at this may cau se burns during the oil le vel check operation . Wait fo r the temperat ure to go down before starti ng the operatio When l oosening the cap, d o not loosen it su ddenly. Loose n it gradually. The inside of th e case is under high pressure , so if the is l oosened suddenly, oil m ay s purt ou t and cause b 1. Turn slowly pressure, the n remov e the cap 2. Remove bolt (1), then remove cover ( 3.
Remove O-ri ng (3), s pring (4), valve (5), element (6), and strainer (7), t hen was h the inside of t he case and of the and s trainer. 4. Prepare a n valve , and sp 5. Coat the O-ri ng thinly with clean oil, t hen install it. 6. Insta ll cover (2) with b olts (1). If the filte r Maintenance c autio n lamp (if e quipped) lig hts up when the engine c oolant temperature gauge is in the white range and the engin e is running at 1200 to 210 0 rpm, replace the elemen t immediately