. SAFETY PRECAUTIONS FOR OPERATION 2 - 20 ENSURE GOOD VISIBILITY This machine is equipped with mirrors to ensure good visibility, but even then there are places that cannot b e seen from the operator's seat, so be careful when operatin g. When traveling or performing operations in places wi th poor visibility, it is impossible to check for obstacles in the area around the machine and to check the condition of the jobsite. This leads to danger of serious personal injury or death. When traveling or performing operations in places with poor visibility, always observe the followin Position a signalman if there are areas where the Only 1 signalman should give signals.
When working in dark places, turn on the workin additional lighting in the work area if necessary. Stop operations if the visibility is poor, such as in When checking the mirrors installed to the machin e, remove all dirt and adjust the angle of the mirror to e nsure good visibility. If the machine is equipped with cameras, clean of f any dirt from the lens and make sure that the camera gives a clear view. CHECKING SIGNS AND SIGNALMAN'S SIGNALS Set up signs to inform of road shoulders and soft ground. If the visibility is not good, position a signalman if necessary. Operators should pay careful attention to the signs and follow the instructions from the signalman.
Only 1 signalman should give signals. g of all signals and signs before starting work. Make sure that all workers understand the meanin BEWARE OF ASBESTOS DUST Asbestos dust in the air can cause lung cancer if it is inhaled. There is danger of inhaling asbestos when w orking on jobsites handling demolition work or work handlin g industrial waste. Always observe the following. st in the air, n, and make operation. work site and Spray water to keep down the dust. Do not use compressed air. If there is danger that there may be asbestos du always operate the machine from an upwind positio sure that all workers operate on the upwind side. All workers should use anti-dust masks.
Do not allow other persons to approach during the Always observe the rules and regulations for the environmental standards. This machine does not use asbestos, but there is a da nger that imitation parts may contain asbestos, so alwa ys use genuine Komatsu parts.