. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) (MT: Metric Ton; ST: Short Ton) OTHER DATA 6 - 53 TOTAL PAYLOAD, OVERALL NUMBER OF CYCLES DAT A The total payload a nd overall number o f cycles from any desire d time ar e calculated and ar e recorded with each act of dumping. The calculation of b oth value s is s tarte d from t he point where t he ZERO CLEAR switch is pressed f or the total payload and overall number o f cycles. Both tota l values ca n be displayed on th e monitor panel by the using the operation given in "FORCED DISPLAY OF TOTAL PAYLO AD AND O VERALL NUMBER OF CYCLES (PAGE 6 -56)".
(See the same section for details of th e method for Z ERO CLEAR.) d automatically when dumping. The total payload is also displaye d automatically when dumpin The maximum limit t hat can b e recorded for the t otal payload and overall n umber of cycles is 999900.0 metric tons or s hort t ons, and 9 999 cycle s.
Item Unit Range Total payload Overall number of cyc Year (last 2 digits) Month Day Time Hour Time Min MT or ST les Times Year Month Day Hour Minute 0 - 999900.0 0 - 9999 0 - 99 1 - 12 1 - 31 0 - 23 0 - 59 This shows the total value from the zero clear point Data and time shows time of zero clear operation Content Item Unit Range Set data for operator check mode Machine ID Open ID Speed limit Option code Integer Integer km/h Integer 0 - 200 0 - 200 0 - 99 0 - 11 Set using switch input operation For details, see section on operator check mode Calibration data Ye ar (last 2 digits) Month Day Time Hour Time Min Year Month Day Hour Minute 0 - 99 1 - 12 1 - 31 0 - 23 0 - 59 Data and time when calibration was carried out Data written by user Data 1 Data 2 Data 3 Data 4 - - - - 20 characters 20 characters 20 characters 20 characters Comments which can be written freely to the payload meter.
However, they can only be input using the cable communications from the personal computer. (See the software manual.)