. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) CARRYING OUT CALIBRATION WHEN CARRYING OUT CALIBRATION Step 5 to 7 are additional items to perform when installing new parts, but carry out these steps also to ensure accuracy. 6 - 55 Carry out calibration in the fol lowing cases. ine, and once a month after that. essure for the suspension cylinder has been adjusted. (When the suspension is en modified and the mass of the machine when empty has changed more than 100 ssure sensor has been replaced. een done to suspension relared parts. When delivering the mach When the oil and gas pr adjusted.) When the chassis has be kilograms.
When the suspension pre When anything eles has b een done to suspension relared parts When the condition of the machine as judged by the payload m eter is different f rom the ac tual conditio n of the dump truck. (See the prec autions for "DISPLAY DURING NOR MAL OPERATIO NS (PAG E 6-44)".) METHOD OF CARRYING OUT CALIBRATION (METHOD OF OPERATION) 1. Empty the dump body. When doing this, remove all the mud that is stuck to the dump body. 2. Move the gear shift lever to the N position and keep CAL/CLR switch (1) pressed for at least 2 seconds. (The letters CAL flash.) 3. Drive the machine at a speed of 10 km/h (6.2 MPH). 4.
When the travel speed reaches 10km/h (6.2 MPH), press CAL/CLR switch (1). In this condition, continue to drive the machine, and if the display changes to the time display sfter approx. 30 seconds, the procedure is completed. 5. Move the machine to a safe place and stop the engine. 6. Start the engine again. 7. Move the dump lever as follows: FLOAT -> RAISE -> LOWER -> FLOAT. 1. Empty the dump body. W that is stuck to the dump 2. Move the gear shift lever switch (1) pressed for at flash.) 3. Drive the machine at a sp 4. When the travel speed CAL/CLR switch (1). In t machine, and if the displ approx. 30 seconds, the 5. Move the machine to a sa 6. Start the engine again. 7.
Move the dump lever as f -> FLOAT. 1. Empty the dump body. W Carry out this operation on flat, level ground. istance: approx. 100m (328 ft 1 in)) ravel speed to a range of 5 to 10 km/h (3.1 to 6.2 MPH). ed in the memory, and is retained even if the power is switched OFF. Travel in a straight line. (D When traveling, keep the t ravel speed to a range of 5 to 10 km/ h (3.1 to 6.2 MP The calibration date is stor ed in the memory, and is retained ev en if the power i s switched If you want to stop calibrat ion during the operation, when the let ters CAL in Step 2 are flash ing, press C AL/CLR switch (1) and the display will change from a flashing CAL to a flashing SCH.
Pr ess CAL/C LR switch ( 1) again and the display will return to the normal display. During the normal operatio n display, calibration can be carried o ut when the dump lever is at the FLOAT p osition. However, if any errors hav e occurred on the machine, for some of the errors, it may be im possible to c arry out calibration. For details, se e "PROBLEM AND WARNING DISP LAY (ERROR C ODE) (PAG E 6-75)".