. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) rate for cable and ON/OFF the When sending (downloading) the date stored in the payload meter to the personal computer using a communications cable, always set the option code to 0 or 2 before starting. (When PMC or TALKS are installed, set the option code to a number between 4 and 11.) We recommend that you normally set the option cade to 0. (h) Adjusting time, date Use this to set the time and date on the payload meter. Of the functions in the operator check mode, the following can also be set from the personal computer using the personal computer download software supplied by Komatsu.
Machine ID setting Open ID setting Speed limit setting Option code setting Note that the option codes can only be changed from 0 to 2, from 4 to 6, or from 6 to 4. Adjusting time, date For details, see the software manual. 6 - 59 (g) Option code setting This is used when setting the to the desired communications function (RS-232C), ON/OFF for the PMC a nd T ALKS (if equipped), automatic transmission function. The code can be set as shown in the table below.
the for Option code Communications baud rate (bit/sec) Automatic transmission function Option setting TALKS setting PMC setting Data transmission type when completing dumping (when PMC is set) 0 1 2 3 4 5 6 7 8 9 10 11 9600 9600 1200 1200 9600 9600 1200 1200 9600 9600 9600 9600 NO YES NO YES NO YES NO YES NO NO NO NO NO NO NO NO YES YES YES YES YES YES NO NO NO NO NO NO NO NO NO NO YES YES YES YES - - - - - - - - Z1 Z2 Z1 Z2