. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) (c) Display of existing problems/warnings/restore status, status of input signals "N": C1:oo Other than "N" : C1:-- FLOAT: C2:oo Other than FLOAT: C2:-- Engine running: C3:oo Engine stopped: C3:-- 6 - 64 1. When the dis play is F.CHE (flashing) , press TOTAL/SFT switc h (1). The existing problem s or warnings w ill be shown as foll 1) If there a F.--- (flas 2) If there a The error shown as foll ows. re no existing problems or warnings, hing for 6 sec.) is displayed. re any existing problems or warnings, codes are displayed in turn. (The error codes flash for 6 sec.
each.) 1) If there a re no existing problems hing for 6 sec.) is displa 2) If there a re any existing problem codes are displayed in turn. (The error codes fl ash for 6 sec. each.) 2. The system will then automatically proceed to the following display for problems and warnings that have e past. have occurred in th 1) If no prob payload F.--- (flas 2) If any pro The error After all th is display occurred in th 1) If no prob lems or warnings have occurred in the past (ther e is no record of occurrence or r estoration i n the meter), hing for 3 sec.) is displayed. blems or warnings have occurred in the past, but the condition has now been restored, codes are displayed in turn.
(The error codes flash for 3 sec. each.) hing for 3 sec.) is displa 2) If any pro blems or warnings hav e occurred in the past, bu t the condition has now bee n restored codes are displayed in turn. (The error codes fl ash for 3 sec. each.) e error codes for proble ms that occurred in the pa st have been displayed , F.--- (lights up for 3 sec.) ed. 3. The system w ill then automatically pr oceed to the following disp lay for sensor signals i nput t o th e payload m eter. 1) Condition of signal for gearshift l C1:XX (lights up for 3 s 2) Condition of signal for dump leve C2:XX (lights up for 3 s 3) Condition of signal for engine oil C3:XX (lights up for 3 s