. ATTACHMENTS, OPTIONS USE OF REAR VIEW MONITOR SETTING OF REAR VIEW MONITOR CAUTIONS WHEN USING REAR VIEW MONITOR WARNING 6 - 91 HOW TO SET DISPLAY MODE A mark of "CAM1", "DIM", "IRIS" and "ZOOM" appea rs on the upper left side of the monitor display, dependi ng on the sort of ongoing operation. r it lights up (2- second display mode). tion by the following method (continuous display mode). Every mark is set to go off in approx. 2 seconds afte The display can be changed to a constantly lit condi tion by the following method (continuous display mode). 1. Press mark switch (2) while pressing manual sw same time.
A "Cam1" mark lights up on the upper left side o display, and the display mode changes to th display mode. 2. When it is required to return to the 2- second d press mark switch (2), while pressing manual sw same time, the same way as in step 1 above. After a "Cam1" mark is lit for approx. 2 seconds left side of the monitor display, only the mark dis the display mode changes to the 2- second displ 1. Press mark switch (2) while pressing manual sw itch (1) at the f the monitor e continuous isplay mode, itch (1) at the on the upper appears, and ay mode. ontinuous display mode, the display is lit all the time in the e monitor display goes off, as well.
REMARK In either case of the 2- second display mode and c remaining time after the mark goes off and before th Do not attempt to disassemble or modify the monitor. T here is a danger of electric shock or fire. Do not attempt to open the monitor backside cover. The re is a danger of electric shock, as high voltage power is conducted internally. Do not use the monitor if it is suspected of defect. There is a fear of electric shock or fire, should it be used in spite of a d efect. In that case, ask your Komatsu distributor for repair or r eplacement.
In case a foreign material has got into the monitor or it g ets wet, or if a smoke comes out of the monitor or it gives a bad smell, stop the use immediately. It poses a big danger to use the Komatsu distributor. When replacing a fuse, be sure to use one with the sp capacity be used, it can cause fire. monitor when any such abnormality exists. In that case, consul t your ecified capacity of 3A. Should a fuse with a higher- than- specified As a general rule, this product should be replac ed after a total usage time of approximately 3000 hours (or ording to usage conditions. et cloth after having well wrung the water out. thinner or alcohol.
approximately 3 years), though this may differ acc When cleaning the monitor, use dry soft cloth or w If it is very dirty, use neutral detergent. Do not use Sometimes an image on the monitor display is blur red due to the camera lens being smeared. In that case, clean the camera lens with dry soft cloth or wet cloth aft er having well wrung the water out.