. ATTACHMENTS, OPTIONS EXTERNAL POWER SOURCE TYPE ELECTRIC HEATER MANUFACTURING EXTERNAL POWER SOURCE INPUT CABLE It is required to purchasing and processing the external power source input cable locally to match the conditions. CABLE SPECIFICATIONS AND INSTALLING PROCEDURE 1. Purchase locally 3-core chloroprene sheath cabtyre cable, referring to the specifications in the diagram on the right. The nominal cross-section area should be 5 to 8mm 2 . Select a cable that is able to stand voltage of 3000V per minute. To prevent any drop in voltage, make the length less than 30m (98ft 5in). the cable according to the table below.
CAUTION 6 - 95 It is required to purchasing and This does not mean that any ca When purpose the cable, make . Connect a plug (175-06-378 connector and each one is marked with a contact symbol, Solder the contact and core wire to connect them. To prevent short circuits caused by contact between the conductors, insulate the soldered parts Always use plug 175-06-37871. If another plug is sued, it cannot be connected with the external power source input socket (rece