. OPERATION EXPLANATION OF COMPONENTS Position D : REMARK Positions 6 - L: If the dump control lever is not at the FLOAT position or the dump body is still raised, and the gear shift lever is When the wheel brake is applied, part (A) of the stop / tail lamp lights up. 3 - 13 This is the positi If the dump body is still raised, the trans mission is fi xed in 1st s peed and will not shift to any o ther speed range.
When traveling, lower the dump body, set the dump control lever to FLOAT, then press the lock button on the leve r and move the lever t To comply with t he EU safety standards (EN 474-6 5.1.3), if th e machine travels with the du mp body not completely lowered, the tra nsmission is fixed in 1s t and the g ear cannot be shifted. Select the desir ed position in places wh ere it is difficult to trav el at high speed, when traveli ng on soft ground, when starting off up a slope when the machin e is loade d, or when using the engine as a brake when traveling downhill.
When switching between FORWARD and REVERSE, relea se the accelerator pedal, dep ress the brake pe dal to stop the machin e completely, then run t he engine at low idle a nd change the direction. Pre ss the lock button o n the gear shift lever and move the lever fro m position N to positio n R or to any position from D to 6. moved from pos ition N to any other po sition, the c entral warn ing lamp lights up and the al arm buzzer sounds Do not place the gear shift lever in positi on N when the machin e is traveling. It will be imposs ible for the transmission to control the tra vel speed. ACCELERATOR PEDAL ator pedal (5) to adjust the engine speed.
Use this acceler ator pedal (5) to adjust the engine The engine spee d can be adjusted freel y between l ow idle and full throttle by the amount tha t the pedal is depressed. BRAKE PEDAL edal (6) to apply the front brakes and rear brakes to adjust the travel speed of the machine. Use this brake p edal (6) to apply the fr ont brakes and rear br akes to adjust the travel spe ed of the machine. The braking forc e of the front brakes a nd rear brakes can be adjusted by the amount that the pedal is depressed.