Install the camshaft. Attaching camshaft ! Apply molybdenum disulfide to the bushing or the Tightening Torque : 8-10 N-m bearing. ! Insert the camshaft into the pump body with transmission shaft CMP at the lowered position (gear B touching the pump body). ! Be careful that the cam and gear B do not interfere with each other. ! (Especially for 4 cylinder engine, note that the Checking backlash ! Rotate camshaft to check that transmission shaft ! The shaft can be inserted with the key of the phase in which the cam passes is limited.) rotates smoothly. driving side press-fitted to the camshaft. ! Fix transmission shaft from upper surface of the Be careful not to damage the camshaft bushing.
housing, and turn the camshaft to check the backlash. Backlash must be in the range from 0.2 to 1.5 degree. Note: When measuring at the position of camshaft driving side key (at the center of the key as shown below), the displacement must be in the range from 0.03 to 0.25. Position the transmission shoe of the transmission shaft CMP as shown in the illustration. 31 Rack plug Tighten the rack plug. (If rack plug has been removed.) Tightening Torque : 79-84 N-m