3.4. Re-assembling the Governor Install the shim to the shaft, (control lever). Governor Body Parts Install the regulator lever. Pierce the spring, (control lever) through the lock nut, (control lever) and fasten it to the thread of the shaft, (control lever). Pierce the governor lever CMP and shim through the governor lever shaft and assemble. Measure the side clearance of the tension lever with thickness gauge. Standard: 0.3 to 0.6 mm (adjusting with shim) Fasten the nut, (control lever). Tightening Torque : 19.6-24.5 N-m Measure the side clearance with thickness gauge. Fit the governor lever shaft with the removal stop, (governor Standard:
0.3 to 0.6 mm (adjusting with shim) lever shaft) and fasten the removal stop bolt . 39 Governor Lever CMP End Float Adjust Shim