General Safety at Job Site SAFETY Before starting operations, thoroughly check the area for any unusual conditions that could be dangerous. Know where to report an accident or fire. In case of an emergency, have a local emergency phone number available. Be careful when operating around or near open burning operations. Maintain the fire extinguisher on the machine and a second one at the job site. Keep the machine clean, especially from flammable materials such as trash, grease, oil, or fuel. Keep all safety equipment in good working condition. Check the terrain and condition of the ground at the work site, and determine the safest method of operation.
Do not operate where there is a hazard of landslides or falling rocks. If water lines, gas lines, or high-voltage electrical lines may be buried under the work site, contact each utility company and have them identify the location of these lines. Take action to prevent unauthorized people from approaching the job site. When working on public roads, position flagmen and erect barriers to ensure the safety of passing traffic and pedestrians. When traveling or operating in shallow water or on soft ground, check the shape and condition of the bedrock, and the depth and speed of flow of the water before starting operations.
Conduct periodic safety training and familiarize all personnel with emergency procedures. Working on Loose Ground Avoid traveling or operating your machine too close to the edge of cliffs, overhangs, and deep ditches. The ground may be weak in such areas. If the ground could collapse under the weight or vibration of the machine, there is a hazard that the machine may fall or tip over. Remember that the soil is loose after heavy rain, blasting, or after earthquakes. When working on embankments or near excavated ditches, there is a hazard that the weight and vibration of the machine could cause the soil to collapse.
Before starting operations, take steps to ensure that the ground is safe and to prevent the machine from rolling over or falling. Safety Features Be sure that all guards and covers are in place especially after servicing the machine. Have guards or covers repaired immediately, if they are damaged. See “Starting Engine” on page 2-99.. Use safety equipment such as safety locks and seat belt properly. See “Seat Belt Inspection” on page 1-21. Never remove any safety features. Always keep them in good operating condition. Always secure the machine in a safe position. See “Parking the Machine” on page 1-33. and “Parking the Machine” on page 2-152.. Seat belt:
See “Inside Operator’s Compartment” on page 1-16. Improper use of safety features could result in serious bodily injury or death. Be sure the machine has the correct equipment required by local rules and regulations. WA380-6 1-11