SAFETY Checks Before Starting Engine, Adjustments Before starting the engine, perform the following checks and adjustments to confirm that there is no problem with operating the machine. If this step is not performed properly, there is a danger of serious personal injury to the operator or damage to the machine during operation. Clean all windows and mirrors on the machine, then adjust all mirrors to prevent any reduction in visibility. Securely fix frame lock lever (1) at the FREE position. Perform pre-operational checks of the machine. See “Precautions Before Starting Work Operations” on page 2-77.. Remove all dirt from the front lamps, work lamps, and combination lamps.
Remove mud, dust, and debris accumulated around the movable parts of the accelerator and brake pedals. Check and make sure the pedals work properly. Walk around the machine and make sure there are no persons or obstacles above, below, or around the machine. Adjust the operator’s seat so it is easy to see to the front of the machine. Fasten your seat belt. Check for damage or wear to the seat belt or seat belt mounts. Adjust the mirrors so the rear of the machine can clearly be seen from the operator’s seat. See “Adjust Mirrors” on page 2-95.. Check and be sure that the gauges and meters work properly, and the work equipment levers are at the Neutral position.
Make sure the parking brake switch is in the ON position (A) Make sure that work equipment lock lever (1) is in the LOCK position. 1-24 WA380-6