EPA07 MBE 4000 SERVICE MANUAL SCOPE AND USE OF THIS MANUAL This manual contains complete instructions on operation, adjustment (tune-up), preventive maintenance, and repair (including complete overhaul) for the MBE 4000 engine. This manual was written primarily for persons servicing and overhauling the engine. In addition, this manual contains all of the instructions essential to the operators and users. Basic maintenance and overhaul procedures are common to all MBE 4000 engines, and apply to all engine models. This manual is divided into numbered sections. Section one covers the engine (less major assemblies).
The remaining sections cover a complete system such as the fuel system, lubrication system, or air system. Each section is divided into subsections which contain complete maintenance and operating instructions for a specific engine subassembly. Each section begins with a table of contents. Pages and illustrations are numbered consecutively within each section. Information can be located by using the table of contents at the front of the manual or the table of contents at the beginning of each section. Information on specific subassemblies or accessories within the major section is listed immediately following the section title.
GENERAL DESCRIPTION The MBE 4000 Engine described in this manual is a water-cooled, four-stroke, direct injection diesel engine. The cylinders are arranged in line. Each cylinder has a separate fuel injection pump (unit pump) with a short injection line to the injection nozzle, which is located in the center of the combustion chamber. The unit pumps are attached to the crankcase and are driven from the camshaft. Each cylinder has two intake valves and two exhaust valves. Charge-air cooling and an exhaust gas turbocharger are standard equipment on all MBE 4000 engines. The engine is equipped with a fully electronic control system.
Besides the engine and its related sensors, this system is composed of the Motor Control Module (MCM), and the Common Powertrain Controller (CPC). The two units are connected by a proprietary datalink through which all necessary data and information can be exchanged. Engine braking is controlled by a pneumatically-operated exhaust brake and by a hydraulically operated constant throttle system. For greater braking power, an optional engine brake is available. The cylinder block has integrated oil and water channels. The six individual cylinder heads are made of cast iron. The cylinder head gasket is an adjustment-free seal with elastomer sealing elements.
The pistons are made of aluminum alloy with ring carriers and a shallow combustion chamber recess. The pistons are cooled by oil spray nozzles. The crankshaft is precision-forged with seven main bearings and eight custom-forged counter weights, and a vibration damper at the front end. The camshaft is made of induction-hardened steel and has seven main bearings. Each cylinder has cams for intake and exhaust valves and a unit pump. The valves are controlled by mushroom tappets, pushrods, and rocker arms. The intake and exhaust valves are opened and closed by a valve-guided bridge. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3