TRAVEL PRECAUTIONS When traveling, wheel loader always keeps lights on; make sure that you are in compliance with all state and local regulations concerning warning flags and signs. Never turn the starter switch to the "O" (OFF) position when traveling. It is dangerous if the engine stops when the machine is traveling. It will be impossible to operate the steering unless the unit is equipped with an emergency steering system. Pilot control valve lever (joystick) should not be operated while traveling. Lower work equipment so that it is 400 mm (16 in) above ground. Never travel over obstacles or slopes that will cause machine to tilt severely.
Travel around any slope or obstacle that causes 10 degrees tilt, or more. Do not operate the steering suddenly. The work equipment may hit the ground and cause the machine to lose its balance, and this may damage the machine or structures in the area. When traveling on rough ground, travel at low speed, and avoid sudden changes in direction. Always keep to the permissible water depth. When traveling over bridges or structures on private land, check first that the bridge or structure can withstand the weight of the machine. When traveling on public roads, check with the local authorities and follow their instructions.
SLOPING TERRAIN REQUIRES CAUTION Dig evenly around work site whenever possible, trying to gradually level any existing slope. If it’s not possible to level area or avoid working on a slope, reducing size and cycling rate workload is recommended. TURBO-II 400 mm(16'') On sloping surfaces, use caution when positioning wheel loader before starting a work cycle. Stay alert for instability situations to avoid getting into them. For example, you should always avoid working bucket over downhill side of machine when parked perpendicular to slope. Avoid full extensions of bucket in a downhill direction.
Lifting bucket too high, too close to machine, while wheel loader is turned uphill can also be hazardous. TURBO-II 400 mm(16'') AHO0970L Figure 17 S0103010K Page 19 Wheel Loader Safety