2) 2) DISASSEMBLY DISASSEMBLY After supporting the front frame and the rear frame as horizontally as possible using wood blocks and jacks, disassemble as follows: In order to facilitate the disassembly/assembly of the center pivot pins, remove the drive shaft, hydraulic line and steering cylinder first. (1) Maintain the horizontal level of front frame (27) and rear frame (28), and then remove hexagon bolt (6, 23, 24), washer (20, 25) and plate (21, 22). UPPER 24 25 6 22 (2) Take out upper pin (11) to the downside using a metal punch. 16 27 28 21 11 20,23 74095SE14 (3) Maintain the front frame horizontal level, remove hexagon bolts (6) and then remove the plate (10) and shims (14, 15, 26).
LOWER 7 (4) Take out lower pin (7) to the upside using a metal punch carefully. 27 (5) Jack up or lifting the front frame (27) slightly, the collar (9) protrudes over the rear frame. Remove the collar (9). 9 14,15,26 (6) Lift the frame by passing the slinging wire rope at four positions of front frame, in order to separate it from the rear frame. 28 6 10 74095SE15 (7) Support the front frame safely. 5-43