10 SEBU8598 Safety Section Burn Prevention Never use compressed air for cleaning. Dispose of Waste Properly Avoid brushing materials that contain asbestos. Avoid grinding materials that contain asbestos. Use a wet method in order to clean up asbestos materials. A vacuum cleaner that is equipped with a high efficiency particulate air filter (HEPA) can also be used. Use exhaust ventilation on permanent machining jobs. Wear an approved respirator if there is no other way to control the dust. Comply with applicable rules and regulations for the work place. In the United States, use Occupational Safety and Health Administration (OSHA) requirements.
These OSHA requirements can be found in “29 CFR 1910.1001”. Illustration 8 g00706404 Improperly disposing of waste can threaten the environment. Potentially harmful fluids should be disposed of according to local regulations. Always use leakproof containers when you drain fluids. Do not pour waste onto the ground, down a drain, or into any source of water. Obey environmental regulations for the disposal of asbestos. Stay away from areas that might have asbestos particles in the air. i03895768 Burn Prevention Softwrap SMCS Code: 1000; 4450; 7405 Keep the engine room ventilation operating at full capacity.
Wear a particulate respirator that has been approved by the National Institute of Occupational Safety and Health (NIOSH). Wear appropriate protective clothing in order to minimize direct contact. Use good hygiene practices and wash hands thoroughly after handling Softwrap material. Do not smoke until washing hands thoroughly after handling Softwrap material. Clean up debris with a vacuum or by wet sweeping. Do not use pressurized air to clean up debris. Do not touch any part of an operating engine or engine aftertreatment system. Allow the engine or the engine aftertreatment system to cool before any maintenance is performed on the engine or the engine aftertreatment system.
Relieve all pressure in the appropriate system before any lines, fittings or related items are disconnected. Coolant When the engine is at operating temperature, the engine coolant is hot. The coolant is also under pressure. The radiator and all lines to the heaters or to the engine contain hot coolant. Any contact with hot coolant or with steam can cause severe burns. Allow cooling system components to cool before the cooling system is drained. Reference: The applicable material safety data sheets can be found at the following web site by searching using part number or the name: http://dsf2ws.cat.com/msds/servlet/ cat.cis.ecs.msdsSearch.controller.
UserIdentificationDisplayServlet Check the coolant level after the engine has stopped and the engine has been allowed to cool. Ensure that the filler cap is cool before removing the filler cap. The filler cap must be cool enough to touch with a bare hand. Remove the filler cap slowly in order to relieve pressure. Cooling system conditioner contains alkali. Alkali can cause personal injury. Do not allow alkali to contact the skin, the eyes, or the mouth.