Section 3 - Maintenance Routine Maintenance Tools Tools Carrying Tools onto the Machine When you carry tools onto the machine you must maintain three points of contact with the machine at all times. Lift tools onto the machine in intervals if necessary. Place the tools down before you adjust your grips on the machine. Do not try to adjust your grips on the machine while holding tools. Locations The machine is equipped with a a grease gun (option) and remote oil-drain tube attachment. The grease gun is stowed into position with clips A , K Fig 2. ( T 3-28) . A The drain tube is stowed into position by its screw thread B , K Fig 3. ( T 3-28) .
Keep the tools in their stowage positions until they are needed. The location of the tools will vary dependant on the machine variant: Fig 2. JS115-JS290 The grease gun is stowed in the toolbox. The toolbox can be locked with the key. B The drain tube is stowed in the service bay behind the cab, next to the engine air filter. The service bay can be locked with the key. JS330/JS360 The grease gun is stowed in the service bay behind the cab. The service bay can be locked with the key. The drain tube is stowed in the radiator bay. The radiator bay can be locked with the key. Fig 3. 3-28 3-28 9803/JSM-0412