OPERATING THE MACHINE PRECAUTIONS FOR SPECIAL OPERATIONS WORKING IN WATER While operating in water or on swampy ground, the water must not reach the underside of the axle housing. Wash the machine after the work has been finished and check the lubricating points. WORKING ON SNOW Adhere to the instructions in the chapter "Safety", "Working on snow". DUMPING ON STEEP SLOPES Adhere to the instructions indicated in the chapter "Safety", "Loading". WORKING IN THE VICINITY OF ELECTRICAL OVERHEAD LINES Adhere to the instructions indicated in the chapter "Safety", "Working Close to Overhead Power Transmission Lines".
OPERATION ON SLOPES Adhere to the instructions indicated in the chapter "Safety", "Driving On Slopes". WORKING ON LOOSE SOIL Adhere to the instructions indicated in the chapter "Safety", "Working on loose soil". AFTER THE WORK IS FINISHED 1. Walk around the machine and visually inspect the work unit, the car body and the chassis. In addition, pay attention to emerging oil and water. Eliminate immediately any fault or defect. 2. Fill up the fuel tank. 3. Remove highly flammable material from the engine room since it represents a fire risk. 4. Clean roughly the chassis landing gear. 5-39