K ENWORTH T680 MIRRORS - SERVICE MANUAL 3. HOUSING REMOVAL AND REPLACEMENT Removal: 1. Remove the main mirror glass (see 2.2). 2. The bezel is equipped with an opening and two molded-in thumb tabs located at the top of the mirror housing as shown in the figure. The opening will give your hand the needed space to push on the thumb tabs which will disengage the housing clips from the bezel tabs. 3. Push on the top two tabs until the housing clips are completely disengaged from the bezel tabs. 4. Once the top two tabs are disengaged, the lower clips will disengage from the bezel tabs by pulling the housing away from the arm. Installation: 1. Position the housing at the back of the mirror. 2.
Engage the bottom of the housing, making sure that the side walls of the housing is inside the lip of the bezel. Also ensure the OAT sensor is positioned correctly on the Left Hand Mirror. Apply force onto the back cover until all the clips have engaged and the housing is seated correctly. Make sure that the side walls of the housing are inside the lip of the bezel. Copyright © Lang Mekra North America 2014 Page 8 of 28 Revised: 03/2014