4. Remove the reservoir cap 1 , add coolant or distilled water to the maximum level mark a , install the reservoir cap, and then install the panel. 1 FULL a Coolant reservoir capacity (up to the maximum level mark): 0.17 L (0.15 Imp qt, 0.18 US qt) LOW EBS00075 CHANGING THE COOLANT 1. Remove: right side panel left side panel Refer to “SEAT AND SIDE PANELS”. front carrier upper panel Refer to “FRONT CARRIER AND FRONT GUARD”. 2. Remove: coolant reservoir cap 1 3. Disconnect: coolant reservoir hose 2 4. Drain: coolant (from the coolant reservoir) 5. Connect: coolant reservoir hose 1 2 6. Remove: radiator cap 1 1 _ A hot radiator is under pressure.
Therefore, do not remove the radiator cap when the engine is hot. Scalding hot fluid and steam may be blown out, which could cause seri- ous injury. When the engine has cooled, open the radiator cap as follows: Place a thick rag or a towel over the radia- tor cap and slowly turn the radiator cap counterclockwise toward the detent to allow any residual pressure to escape. When the hissing sound has stopped, press down on the radiator cap and turn it counterclockwise to remove. 3 - 41 CHECKING THE COOLANT LEVEL/ CHANGING THE COOLANT CHK ADJ WARNING