Belt tension gauge 90890-03170 Rear drive belt tension gauge YM-03170 LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 7. Adjust: steering tension MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Remove the electrical components tray. Refer to “ELECTRICAL COMPONENTS TRAY”. b. Loosen the steering stem bracket bolts 1 , steering stem bearing bolts 2 , and steering stem joint bolts 3 completely. 1 NOTE: After loosening the bolts, be sure to check that the steering stem joint moves smoothly on the serrations of the steering stem and shaft of the EPS unit. 2 3 c. Tighten the steering stem bearing bolts to specification.
Steering stem bearing bolt 50 Nm (5.0 m · kg, 36 ft · lb) LOCTITE ® T R . . d. Tighten the steering stem bracket bolts to specification. Steering stem bracket bolt 50 Nm (5.0 m · kg, 36 ft · lb) LOCTITE ® T R . . e. Tighten the steering stem joint bolts to specification. Steering stem joint bolt 30 Nm (3.0 m · kg, 22 ft · lb) LOCTITE ® T R . . f. Measure the steering tension again. g. Repeat the above procedure until the steer- ing tension is below specification. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 3 - 64 CHECKING THE STEERING SYSTEM CHK ADJ