EBS00016 LOCK WASHERS/PLATES AND COTTER PINS After removal, replace all lock washers/plates 1 and cotter pins. After the bolt or nut has been tightened to specification, bend the lock tabs along a flat of the bolt or nut. EBS00017 BEARINGS AND OIL SEALS Install bearings and oil seals so that the manu- facturer’s marks or numbers are visible. When installing oil seals, lubricate the oil seal lips with a light coat of lithium-soap-based grease. Oil bearings liberally when installing, if appro- priate. 1 Oil seal CAUTION: _ Do not spin the bearing with compressed air because this will damage the bearing surfaces.
1 Bearing EBS00018 CIRCLIPS Before reassembly, check all circlips carefully and replace damaged or distorted circlips. Always replace piston pin clips after one use. When installing a circlip 1 , make sure the sharp-edged corner 2 is positioned opposite the thrust 3 that the circlip receives. 4 Shaft 1 - 10 IMPORTANT INFORMATION GEN INFO