EBS00259 REMOVING THE AC MAGNETO ROTOR 1. Remove: lead holder 1 AC magneto cover NOTE: 1 _ Loosen each bolt 1/4 of a turn at a time, in stages and in a crisscross pattern. After all of the bolts are fully loosened, remove them. 3 2. Remove: AC magneto rotor nut 1 washer 2 NOTE: _ While holding the AC magneto rotor 2 with the sheave holder 3 , loosen the AC mag- neto rotor nut. Do not allow the sheave holder to touch the projection on the rotor. 1 Sheave holder 90890-01701 Primary clutch holder YS-01880-A 1 3. Remove: AC magneto rotor 1 (with the starter clutch) woodruff key 2 CAUTION:
To protect the end of the crankshaft, place an appropriate sized socket between the flywheel puller set center bolt and the crankshaft. NOTE: Use the flywheel puller 2 . Install the flywheel puller bolts to the threaded holes of the starter clutch. Make sure the flywheel puller is centered over the AC magneto rotor. 4 - 45 AC MAGNETO ENG