Й 1 2. Install: dust boot ball bearing 1 circlip 2 double off-set joint 3 clip 4 2 New New NOTE: Securely install the circlip into the groove in the joint shaft. Securely install the clip into the groove in the double off-set joint. Й Й Gear case side 3 4 3. Apply: molybdenum disulfide grease (into the ball joint assembly) NOTE: _ Molybdenum disulfide grease is included in the repair kit. 4. Install: dust boots 1 boot bands 2 , 3 New MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Apply molybdenum disulfide grease into the dust boots. Molybdenum disulfide grease 40 g (1.4 oz) per dust boot (front wheel side) 55 g (1.9 oz) per dust boot (dif- ferential gear case side) b.
Install the dust boots 1 . c. Install the dust boot bands. 7 - 14 FRONT CONSTANT VELOCITY JOINTS AND DIFFERENTIAL GEAR DRIV DRIV