EBS01009 ASSEMBLING THE DIFFERENTIAL GEARS 1. Measure: gear lash Refer to “MEASURING THE DIFFEREN- TIAL GEAR LASH”. 2. Install: differential gear motor 1 MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Slide the shift fork sliding gear 1 , which is installed to the differential gear, to the left to put it into the 2WD mode. 3V b. Connect two C size batteries to the gear motor terminal 2 to operate the pinion gear 3 , and operate it until the mark 4 on the gear is aligned with the mark 5 on the gear motor case. 3 4 5 _ Do not use a 12 V battery to operate the pinion gear. CAUTION: 2 6 c.
Insert 6 mm bolts 6 into the gear motor 7 and use them as a guide to set the motor on the differential gear assembly 8 so that the shift fork sliding gear 9 does not move. 6 7 9 6 _ If the position of the shift fork sliding gear is moved, the position of the differential gear and the indicator light display may dif- fer, and the 2WD or differential lock mode may not be activated. CAUTION: 8 d. Remove the 6 mm bolts, and then install the motor with the gear motor bolts. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 7 - 16 FRONT CONSTANT VELOCITY JOINTS AND DIFFERENTIAL GEAR DRIV DRIV T.R. Differential gear motor bolt 11 Nm (1.1 m · kg, 8.0 ft · lb)