2 1 3 4 f. Attach the ball joint remover/installer, new ball joint (with rubber boot and retaining ring) 1 , installer spacer 6 and installer washer 2 to the steering knuckle 3 . 5 NOTE: Do not tap or damage the top of the ball joint. 6 g. Hold the body 4 in place while turning in the bolt 5 to install the new ball joint 1 into the steering knuckle 3 . h. Remove the ball joint remover/installer. i. Install a new ball joint. NOTE: Always use a new ball joint set. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 3. Check: front wheel bearing 1 Bearings allow play in the wheel hubs or the wheel turns roughly Replace. 2 MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a.
Clean the outside of the steering knuckle. b. Remove the circlip 2 . c. Drive out the bearing. 1 _ Eye protection is recommended when using striking tools. WARNING d. Apply lithium-soap-based grease to the outer side of the bearing. e. Install the new bearing. CAUTION: _ Do not strike the center race or balls of the bearing. Should be made only with the outer race. f. Install the new circlip. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 8 - 45 STEERING SYSTEM CHAS CHAS