SAFETY TRAVELING IN REVERSE Traveling in reverse may pose several hazards. Below is a list if some basic rules to follow when traveling in reverse. Be sure the area behind you is clear of people or objects that might be in the way. Before moving your machine, sound the horn to warn others in your area you are moving. When operating in areas that may pose a hazard or has poor visibility, designate a person to direct your movements. Do not rely totally on the mirrors because blind spots exist. TRAVELING ON ICY OR SNOW-COVERED SURFACES If the ground is icy or covered with snow, the steering may not be as responsive as expected.
To limit the risk resulting from reduced maneuverability, proceed as follows: Engage the four-wheel drive. Four-wheel drive will not affect the braking. Travel at a slow safe speed. Avoid rapid acceleration or braking. Avoid sudden steering movements, especially with a short turning radius. Stopping distances are reduced during slippery conditions. Thus, downshift the transmission and use the engine as a brake to decrease the machine’s speed, and then apply the service brakes. If using the machine for snow plowing, be careful of objects — signs, posts, large rocks, etc. — buried in the snow. WORKING ON LOOSE OR UNSTABLE GROUND To limit the risk when working in these areas:
Avoid operating the machine too close to the edge of a cliff, open trenches, or ditch lines. These areas may collapse under the weight of the machine, causing serious injury to the operator. Keep in mind after a heavy rain or thaw, the surface conditions become less stable. VISIBILITY When visibility decreases due to darkness, turn on the road lights, working lights, or both. If reduced visibility is a result of fog, smoke, whiteout conditions (blizzard), or heavy rain, stop the machine in a safe place as soon as possible. Wait for the conditions to improve before resuming work.
PREVENTING DAMAGE CAUSED BY THE WORK EQUIPMENT Working in tunnels, beneath bridges or under cables (telephone or power) and any other situation where the height is lim- ited, ensure that working with the backhoe or bucket will not cause any damage. WB140PS-2N WB150PS-2N 1-15