SAFETY Angle the loading ramps not greater than 15 degrees. Position the machine squarely with the ramps. Raise the loader bucket high enough to clear all surfaces. Travel straight up the ramp at a slow speed in low range with the bucket (1) facing forward. Do not change direction when on the ramp; if repositioning is needed, back down the ramp and realign the machine to the ramps. After loading the machine, rest the front bucket on the floor, set the machine in neutral and apply the parking brake. Lower the backhoe (2) onto the floor. Set all control locks, including the backhoe lock pin. Turn the ignition off and remove the key.
Secure the machine with chains (4) at the anchor points (A, B). Place chocks (3) behind and in front of each wheel. Once the machine is on the transport truck, measure the maximum height of the machine while on the flat- bed and the weight. The advance information is needed before accessing bridges, tunnels and roads with weight restrictions. Check with local officials for transport regulations throughout the entire route. 1-26 WB140PS-2N WB150PS-2N