2. BATTERY CHARGING WARNING LAMP LIGHTS UP 2. BATTERY CHARGING WARNING LAMP LIGHTS UP (starting switch : ON) · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted. · After checking, insert the disconnected connectors again immediately unless otherwise specified. Check voltage MCU ALTERNATOR S B+ ~ G 20 L 3 P U CN-51 CN-74 5-24 YES Check voltage YES between CN-51 (20) and chassis Check voltage NO between alternator terminal "1" and chassis Voltage : 10~12.5V Engine :
Running NO Cause Remedy Defective cluster Disconnection in wiring harness or poor contact between CN-51 (20)-alternator terminal "1" Defective alternator Replace Repair or replace (after clean) Replace YES 10 ~ 12.5V NO 0V 2 1