SAFETY - General Safety Instructions Standards applicable at the time of manufacture. Even with these safety features, continued safe and reliable operation depends greatly upon regular vehicle maintenance. Follow the maintenance recommendations found in Preventive Maintenance section. This will help preserve your investment. Make sure your vehicle is in top working condition before heading out on the road, it is the responsible driver's duty to do so. Inspect the vehicle according to the Driver's Check List. Use the proper tool for manually rotating the engine. DO NOT attempt to rotate the crankshaft by pulling or prying on the fan.
This practice can cause death, personal injury, equipment damage, or damage to the fan blades, causing premature fan failure. Work areas should be dry, well lit, well ventilated, free from clutter, loose tools, parts, ignition sources and hazardous substances. Wear protective glasses and protective shoes when working. DO NOT wear loose-fitting or torn clothing. Tie back and/or tuck in long hair. Remove all jewelry when working. Before beginning any repair, disconnect the battery (negative [-] cable) and discharge any capacitors. Put a “DO NOT OPERATE” tag in the operator's compartment or on the controls.
Allow the engine to cool before slowly loosening the coolant filler cap to relieve the pressure from the cooling system. 1 General Safety Instructions Important safety notices about operating and servicing your engine. WARNING Improper practices, carelessness, or ignoring any warnings may cause death, personal injury, equipment or property damage. WARNING Removing the fill cap on a hot engine can cause scalding coolant to spray out and burn you badly. If the engine has been in operation within the previ- ous 30 minutes, be very careful in re- moving the fill cap. Protect face, hands, and arms against escaping flu- id and steam by covering the cap with a large, thick rag.
DO NOT try to re- move it until the surge tank cools down or if you see any steam or coolant es- caping. In any situation, remove the cap very slowly and carefully. Be ready to back off if any steam or coolant be- gins to escape. Before performing any repair, read and understand all of the safety precautions and warnings. The following is a list of general safety precautions that must be followed to provide personal safety. Failure to follow these instructions may cause death or injury. Special safety precautions are included in the procedures when they apply.
Keep in mind that even a well maintained vehicle must be operated within the range of its mechanical capabilities and the limits of its load ratings. See the Weight Ratings label on the driver's door edge. Every new vehicle is designed to conform to all Federal Motor Vehicle Safety Y53-1272-1B1 (08/17) 7