CAB AND FRAME ACCESS 1 Batteries Synchronization Climbing onto the Deck Plate The key fob uses one CR2032, 3V battery. Batteries should last approximately three years, depending on use. Consistently reduced range is an indicator that the battery needs replacement. Batteries are available at most discount, hardware, and drug stores. The key fob may need to be synchronized to the truck when the battery is replaced or when the key fob has not been used for an extended period of time. WARNING! When you are climbing onto and off the deck plate, maintain at least three points of contact with your hands on the grab handles and your feet on the steps.
Always face toward the vehicle when entering or exiting the cab and look where you are going. Failure to comply may result in death or personal injury. To Synchronize A Key Fob: 1. Hold the key fob near the receiver which is located behind the speedometer and tachometer. The battery can be accessed by removing the cover of the key fob. After a new battery is installed, the key fob must be synchronized with the vehicle. 2. Press and hold both the Lock and Unlock buttons at the same time for approximately 7 seconds. WARNING! 3. When the key fob is resynchronized, the doors will lock then immediately unlock.
When stepping onto a surface to enter the cab or access the deck plate, only use the steps and grab handles in stalled and designed for that purpose. Failure to use the proper steps and grabhandles could cause a fall which may result in death or personal injury. 4. If the fob fails to synchronize, it could be programmed to a different truck or could have failed. Contact your dealer to re-program your key fob. (04/13) Y53-1200-1B1 1-13