SEATS AND RESTRAINTS 1 5. Pull belt to check for proper fastening and adjustment, as follows: If the belt is locked, lean the body back to remove any tension in the belt. After releasing the belt, allow the belt to retract completely by guiding the belt tongue until the belt comes to a stop. Pull shoulder section to make sure belt fits snugly across the chest and pelvis. There should be less than 1 inch (25 mm) gap between the body and the belt. The shoulder belt must be positioned over the shoulder, it must never rest against the neck or be worn under the arm. Make sure any slack is wound up on the retractor and that the belt is not twisted. To unfasten the belt: 1.
Push in the release button on the buckle. 2. The belt will spring out of the buckle. 1-24 Y53-1200-1B1 (04/13)