OM2026.1 Safety - Section 2 General Safety Page 2-7 ENSURE GOOD VISIBILITY When working in dark places, install working lamps and head lamps, and set up lighting in the work area if necessary. Stop operations if the visibility is poor, such as in mist, snow, or rain, and wait for the weather to improve to a condition that allows the operation to be carried out safely. OPERATE CAREFULLY ON SNOW When working on snowy or icy roads, there is danger that the machine may slip to the side on even the slightest slope, so always travel slowly and avoid sudden starting, turning, or stopping. Be extremely careful when carrying out snow-clearing operations.
The road shoulder and other objects are buried in the snow and cannot be seen. When traveling on snow-covered roads, always install tire chains. AVOID DAMAGE TO DUMP BODY When working in tunnels, on bridges, under electric cables, or when entering a parking place or any other place where there are height limits, always drive extremely carefully and lower the dump body completely before driving the machine. DO NOT GO CLOSE TO HIGH-VOLTAGE CABLES Going close to high-voltage cables can cause electric shock. Always maintain the safe distance given below between the machine and the electric cable. The following actions are effective in preventing accidents:
1) Wear shoes with rubber or leather soles. 2) Use a signalman to give warning if the machine approaches too close to the electric cable. If the work equipment should touch the electric cable, the operator should not leave the operator's compartment. When carrying out operations near high voltage cables, do not let anyone come close to the machine. Check with the electricity company about the voltage of the cables before starting operations. Voltage Minimum Safety Distance 6.6 kV 3 m 10 ft. 33.0 kV 4 m 14 ft. 66.0 kV 5 m 17 ft. 154.0 kV 8 m 27 ft. 275.0 kV 10 m 33 ft.