EXPLANATION OF COMPONENTS OPERATION FUSE NOTICE Before replacing a fuse, be sure to turn off the starting switch. The fuses protect the electrical equipment and wiring from burning out. If the fuse becomes corroded, or white powder can be seen, or the fuse is loose in the fuse holder, replace the fuse. Replace the fuse with another of the same capacity. FUSE CAPACITIES AND CIRCUIT NAMES FUSIBLELINK If the starting motor does not move even when the starting switch is turned to the ON position, there is probably a break in the wire-shaped fusible link (1), so open the engine hood and check or replace.
REMARK A fusible link refers to the large-sized fuse wiring installed in the high current flow portion of the circuit to protect electrical components and wiring from burning, in the same way as an ordinary fuse. 3-30 Fuse capacity Name of circuit (1) 30 A Room lamp, radio (back-up), starting motor terminal B (stop solenoid) (2) 20 A Alarm buzzer, monitor panel, solenoid, pump adjuster (3) 20 A Wiper, radio, horn, window washer, throttle actuator (4) 10 A Light (5) 15 A Heater, additional lamp (if equipped), rear working lamp (6) 20 A Air conditioner, travel alarm (if equipped), limit switch, 2- stage relief solenoid (7) 15 A Spare fuse (8) 20 A Spare fuse (9) 30 A Spare fuse