SEBU7901-01 41 Operation Section Engine Stopping i02069570 After Stopping Engine SMCS Code: 1000 Note: Before you check the engine oil, do not operate the engine for at least 10 minutes in order to allow the engine oil to return to the oil pan. Check the crankcase oil level. Maintain the oil level between the “ADD” mark and the “FULL” mark on the oil level gauge. Note: Only use oil that is recommended in this Operation and Maintenance Manual, “Refill Capacities and Recommendations” article. Failure to do so may result in engine damage. If necessary, perform minor adjustments. Repair any leaks and tighten any loose bolts. Note the service hour meter reading.
Perform the maintenance that is in the Operation and Maintenance Manual, “Maintenance Interval Schedule”. Fill the fuel tank in order to help prevent accumulation of moisture in the fuel. Do not overfill the fuel tank. Allow the engine to cool. Check the coolant level. Maintain the cooling system at 13 mm (0.5 inch) from the bottom of the pipe for filling. Note: Only use coolant that is recommended in this Operation and Maintenance Manual, “Refill Capacities and Recommendations” article. Failure to do so may result in engine damage. If freezing temperatures are expected, check the coolant for proper antifreeze protection.
The cooling system must be protected against freezing to the lowest expected outside temperature. Add the proper coolant/water mixture, if necessary. Perform all required periodic maintenance on all driven equipment. This maintenance is outlined in the instructions from the OEM.