OM2021 12/01 Safety - Section 2 General Safety Page 2-5 PRECAUTIONS DURING OPERATION BEFORE STARTING ENGINE Prevention is the best safety program. Prevent a potential accident by knowing the employer's safety require- ments and all necessary job site regulations. In addition, know the proper use and care of all the safety equipment on the truck. Only qualified operators or technicians should attempt to operate or maintain the Komatsu Truck. Safe practices start before the operator gets to the equipment! SAFETY AT WORKSITE When walking to and from the truck, maintain a safe distance from all machines even if the operator is visible.
Before starting the engine, thoroughly check the area for any unusual conditions that could be dangerous. Examine the road surface in the job site and determine the best and safest method of operation. Choose an area where the ground is as horizontal and firm as possible before carrying out the operation. If you need to operate on a road, protect pedestrians and cars by designating a person for work site traffic duty or by installing fences around the work site. The operator must check personally the work position, roads to be used, and existence of obstacles before starting operations.
Always determine the travel roads in the work site and maintain them so that it is always safe for the machines to travel. If travel through wet areas is necessary, check the depth and flow of water before crossing the shallow parts. NEVER be in water which is in excess of the permissible water depth. FIRE PREVENTION Thoroughly remove wood chips, leaves, paper and other flammable things accumulated in the engine compartment. These could cause a fire. Check fuel, lubrication, and hydraulic systems for leaks. Have any leaks repaired. Wipe up any excess oil, fuel or other flammable fluids. Be sure a fire extinguisher is present and working. Do not operate the machine near any flame.
IN OPERATOR'S CAB Do not leave tools or spare parts lying around in the operator's compartment. They may damage or break the control levers or switches. Always put them in the tool box on the right side of the machine. Keep the cab floor, controls, steps and handrails free of oil, grease, snow, and excess dirt. Check the seat belt, buckle and hardware for damage or wear. Replace any worn or damaged parts. Always use seat belts when operating your machine. VENTILATION FOR ENCLOSED AREAS If it is necessary to start the engine within an enclosed area, provide adequate ventilation. Exhaust fumes from the engine can KILL.