Operation - Section 3 10/00 OM3023 Page 3-8 Operating Instructions 9. Do not use the fire extinguisher for any purpose other than putting out a fire! If extinguisher is discharged, report the occurrence so the used unit can be refilled or replaced. 5. Observe all regulations pertaining to the job site's traffic pattern. Be alert to any unusual traf- fic pattern. Match the truck speed to haul road conditions and slow the truck in any congested area. Obey the spotter's signals at shovel and dump. 10. Do not allow unauthorized personnel to ride in the truck. Do not allow anyone to ride on the ladder or on the deck of the truck. 6.
Do not allow engine to run at "Idle" for extended periods of time. 11. Do not leave truck unattended while engine is running. Shut down engine before getting out. 7. Check parking brake periodically during working shift. Use parking brake for parking and at shovel and dump only. Do not attempt to apply parking brake while truck is moving! MACHINE OPERATION SAFETY PRE- CAUTIONS 8. Proceed slowly on rough terrain to avoid deep ruts or large obstacles. Avoid traveling close to soft edges and the edge of fill area. After the truck engine is started and all systems are functioning properly, the operator must follow all local safety rules to insure safe machine operation. 9.
Truck operation requires concentrated effort by the driver. Avoid distractions of any kind while operating the truck. LOADING If any of the red warning lights come "On" or if any gauge reads in the red area during truck operation, a malfunction is indicated. Stop truck as soon as safety permits, shut down engine if problem indicates and have problem corrected before resuming truck operation. 1. Pull into the loading area with caution. Remain at a safe distance while truck ahead is being loaded. 2. Do not drive over unprotected power cables. 3. When approaching or leaving a loading area, watch out for other vehicles and for personnel working in the area. 1.
Always sound the warning horn before moving the truck. When backing the truck, give back-up signal (three blasts on air horn); when starting forward, two blasts on air horn. These signals must be given each time the truck is moved for- ward or backward. Look to the rear before back- ing the truck. Watch for and obey ground spotter's hand signals before making any reverse movements. Spotter should have a clear view of the total area at the rear of the truck. 4. When pulling in under a loader or shovel, follow "Spotter" or "Shovel Operator" signals.
The truck operator may speed up loading operations by observing the location and loading cycle of the truck being loaded ahead, then follow a sim- ilar pattern. 5. Operator should remain in truck cab with engine running while truck is being loaded. Place Transmission Range Selector in "Neutral" and apply Parking Brake lever. 2. Operate the truck only while properly seated with seat belt fastened. Keep hands and feet inside the cab compartment while truck is in operation. Keep a firm grip on steering wheel at all times. 3. Check that all mirrors are not damaged, clean, and are properly positioned for optimum view.
If operator must leave truck cab during loading, engine must be shut down and parking brake applied. DO NOT use emergency brake for park- ing. Remain far enough away from truck to avoid being struck by flying material. 4. Check gauges and instruments frequently dur- ing operation for proper readings. 6. When truck is loaded, pull away from shovel as quickly as possible, but with extreme caution.