5-101.bk Page 28 Friday, March 17, 2006 11:05 AM FIRE RING GROOVE CUTTING PROCEDURE Refer to Figure 5-30. Refer to Figure 5-29. 2. Position cylinder head so threaded section of hold-down capscrews can be reached. Install spacer (3), washer (2) and wing nut (1). Lightly tighten wing nut. 1. Place cutter base (1) on cylinder head (2). Insert hold-down capscrews into appropriate mounting holes (per application) until hold- down capscrews bottom out in mounting holes. The cutter base must be free to move. 1 2 Figure 5-29 — Cutter Base Alignment 200288a 1 2 3 200289a Figure 5-30 — Fastening Cutter Base Page 5-28 200 BENCH PROCEDURES 1. Cutter base 2. Cylinder head 1. Wing nut 2. Washer 3. Spacer