SEBU7899-05 63 Maintenance Section Maintenance Interval Schedule i04760784 Maintenance Interval Schedule (Engines Which Have Shallow Oil Pans) Power Take-Off Clutch - Check ............................ 97 Walk-Around Inspection ........................................ 99 Every Week Jacket Water Heater - Check ................................ 94 SMCS Code: 1000; 4450; 7500 Initial 250 Service Hours (or at first oil change) Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures:
all adjustments, the use of proper lubricants, fluids, filters, and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed. Engine Valve Lash - Check ................................... 85 Engine Valve Rotators - Inspect ........................... 85 Every 250 Service Hours Battery Electrolyte Level - Check .......................... 66 Coolant Sample (Level 1) - Obtain .......................
71 Cooling System Supplemental Coolant Additive (SCA) - Test/Add ................................................. 73 Engine Crankcase Breather - Clean ..................... 80 Engine Oil Sample - Obtain .................................. 82 Engine Oil and Filter - Change ............................. 82 Fuel System Primary Filter (Water Separator) Element - Replace .............................................. 88 Fuel System Secondary Filter - Replace .............. 90 Grounding Stud - Inspect/Clean/Tighten ............... 91 Hoses and Clamps - Inspect/Replace .................. 92 Radiator - Clean .................................................... 97 Note:
Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours, and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed. Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems) Refer to this Operation and Maintenance Manual, “Refill Capacities” in order to determine the type of oil pan with which your Cat C18 Industrial Engine is equipped. Coolant Sample (Level 2) - Obtain ....................... 72 Every 500 Service Hours Products that operate in severe operating conditions may require more frequent maintenance.
Refer to this Operation and Maintenance Manual, “Severe Service Application” to determine if the engine is operating in a severe service application. Belts - Inspect/Adjust/Replace .............................. 67 Starting Motor - Inspect ........................................ 98 Turbocharger - Inspect .......................................... 98 Water Pump - Inspect ......................................... 100 When Required Every 2000 Service Hours or 1 Year Battery - Replace .................................................. 65 Battery or Battery Cable - Disconnect .................. 66 Coolant - Change ..................................................
68 Coolant Extender (ELC) - Add .............................. 70 Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace ........................................ 76 Engine Oil and Filter - Change ............................. 82 Engine Storage Procedure - Check ...................... 85 Fuel System - Prime ............................................. 86 Alternator - Inspect ............................................... 65 Every Year Coolant Sample (Level 2) - Obtain ....................... 72 Every 3000 Service Hours or 3 Years Aftercooler Core - Clean/Test ............................... 65 Coolant Temperature Regulator - Replace ...........
72 Crankshaft Vibration Damper - Inspect ................. 74 Driven Equipment - Check .................................... 75 Electronic Unit Injector - Check/Replace .............. 75 Engine - Clean ...................................................... 76 Engine Mounts - Inspect ....................................... 81 Engine Protective Devices - Check ...................... 84 Engine Valve Lash - Check ................................... 85 Engine Valve Rotators - Inspect ........................... 85 Fan Drive Bearing - Lubricate ............................... 86 Speed Sensor - Clean/Inspect ..............................
98 Daily Coolant Level - Check .......................................... 70 Engine Air Cleaner Service Indicator - Inspect ..... 79 Engine Air Precleaner - Check/Clean ................... 80 Engine Oil Level - Check ...................................... 81 Fuel System Primary Filter/Water Separator - Drain ................................................................... 88 Fuel Tank Water and Sediment - Drain ................. 90