EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 2.2 REMOVAL OF CAMSHAFT AND ROCKER SHAFT/ENGINE BRAKE ASSEMBLY Remove as follows: 1. Turn engine OFF, (key OFF, engine OFF). 2. Steam clean the engine. 3. Disconnect the battery power to the engine. Refer to OEM procedures. 4. Remove the air cleaner and the turbocharger inlet pipe and hose. Refer to OEM procedures. 5. Remove air cleaner housing. Refer to OEM procedures. 6. Remove the rocker cover. Refer to section 1.2. 7. Remove the two 14-pin fuel injector harness connectors (1) from the camshaft housing housing (2). NOTE: Top Dead Center (TDC) can be confirmed by installing camshaft timing tool.
For the DD13 use Camshaft Timing Tool (W470589034000). For the EPA07 DD15 use Camshaft Timing Tool (W470589054000). For the EPA10 DD15 use Camshaft Timing Tool (W470589104000). 8. Using Engine Barring tool (J-46392), rotate the crankshaft to TDC on cylinder No. 1. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 2-7