SERVICE INFORMATION 00-19 Adjustment 1. Loosen the lock nuts on the steering knuckle or the axle case. 2. Adjust projecting height of the stopper bolts. 3. Tighten the lock nuts to specified torque. Wishbone Suspension Tighten: Stopper bolt to Rigid suspension: 186 N m (19.0 kg m / 137 lb ft) NPS: 49 N m (5.1 kg m / 36 lb ft) Wishbone suspension: 82 N m (8.4 kg m / 61 lb ft) Rigid Suspension N3A0022E Camber Angle All Model except NPS Toe-in can be checked on the gauge simultaneously. 1. When inspection of turning radius is completed, calibrate the scale of the turning radius gauge to zero. 2. Remove the front hub cap.
Install camber, caster and king pin inclination gauge on end of the knuckle spindle horizontally. N3A0020E Notice: When removing hub cap, take care so as not to cause damage to gauge fitting face at end of the spindle. If end of the spindle has been scratched or damaged, correct before setting the gauge. NPS N3A0021E N3A0023E Legend 1. Camber angle