R2.8 CM2220 R101B Engine Lifting Section 1 - Installation by Subsystem Page 1-5 Figure 5 - Engine Mount Location 1 Rear face of flywheel housing 2 Rear face of flywheel housing to center of bolt pattern – 355 mm [13.97 in] 3 Center of top-to-bottom bolt pattern – 65 mm [2.56 in] 4 Center of front-to-rear bolt pattern – 104 mm [4.09 in]. Engine Lifting (388-002) General Information The engine lifting equipment must be designed to lift the engine and transmission as an assembly without causing personal injury. WARNING The engine oil sump or cover plate will not support the weight of the engine and/or the engine transmission assembly. Do not set the engine on the oil pan.
Doing so can result in equipment damage, severe personal injury, or death. WARNING Personal protective equipment must be considered when performing many tasks on the engine or vehicle. Personal protective equipment such as but not limited to: eye protection, steel toe shoes, and mechanic gloves should be worn. Securing the vehicle that is to be worked on is critical. Do not work under an engine or vehicle that is not properly supported. CAUTION To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com