TRANSPORTING THE EXCAVATOR Figure 10-30-2 When transporting the machine, observe the rules, motor vehicle laws and vehicle limit ordinances. Use a transport and towing vehicle of adequate length and capacity. 1 Secure the parking brakes and block the wheels of the transport vehicle. Align the ramps with the center of the transport vehicle. Secure the ramps to the truck bed and be sure ramp angle does not exceed 15 degrees. Use metal loading ramps with a slip resistant surface. Use ramps that are the correct length and width, and can support the weight of the machine.
P-32598 The rear of the trailer must be blocked or supported when loading or unloading the excavator to prevent the front of the transport vehicle from raising. Figure 10-30-3 Determine the direction of the track movement before moving the machine (blade forward). Figure 10-30-1 1 P-32603 Fasten chains to the front corners of the blade (Item 1) [Figure 10-30-2] and to the tie down loop at the rear track frame (both sides) (Item 1) [Figure 10-30-3] to prevent it from moving when going up or down slopes, or during sudden stops. P-32599 Use chain binders to tighten the chains and then safely tie the chain binder levers to prevent loosening.
Move the machine forward onto the transport vehicle [Figure 10-30-1] . Do not change direction of the machine while it is on the ramps. WARNING Lower the boom, arm and bucket to the transport vehicle. Adequately designed ramps of sufficient strength are needed to support the weight of the machine when loading onto a transport vehicle. Wood ramps can break and cause personal injury. Stop the engine and remove the key. Put blocks at the front and rear of the tracks. W-2058-0494 442 Excavator 10-30-1 Service Manual