Even going close to high-voltage cables can cause electric shock, which may cause serious burns or even death. Always maintain a safe distance (see the table on the right) between the machine and the electric cable. Check with the local power company about safe operating procedure before starting operations. To prepare for any possible emergencies, wear rubber shoes and gloves. Lay a rubber sheet on top of the seat, and be careful not to touch the chassis with any exposed part of your body. Use a signalman to give warning if the machine approaches too close to the electric cables. When carrying out operations near high voltage cables, do not let anyone near the machine.
If the machine should come too close or touch the electric cable, to prevent electric shock, the operator should not leave the operator's compartment until it has been confirmed that the electricity has been shut off. Ensure Good Visibility This machine is equipped with mirrors to improve the visibility, but even with mirrors, there are places which cannot be seen from the operator's seat, so always be careful when operating.
When operating or traveling in places with poor visibility, if it is impossible to confirm the condition of the job site or if an obstacle is in the area around the machine and there is danger that the machine may suffer damage or the operator may suffer serious personal injury. When operating or traveling in places with poor visibility, always observe the following items: If the visibility cannot be sufficiently assured, position a flagman. The operator should pay careful attention to the signs and follow the instructions of the flagman. The signals should be given only by one flagman.
When working in dark places, turn on the working lamps and front lamps of the machine, and if necessary, set up additional lighting in the area. Stop operations if there is poor visibility, such as in fog, snow, rain, or sand storms. Check the mirrors on the machine before starting operations every day. Clean off any dirt and adjust the view to ensure good visibility. In areas where it is impossible to confirm the area behind the machine and observation cameras have been set up, clean off any dirt from the lens and make sure that the camera gives a clear view of the rear. Ventilation for Enclosed Area Exhaust fumes from the engine can kill.
If it is necessary to start the engine within an enclosed area, or when handling fuel, flushing oil, or paint, open the doors and windows to ensure that adequate ventilation is provided to prevent gas poisoning. Signalman's Signal and Signs Set up signs to inform of road shoulders and soft ground. If the visibility is not good, position a signalman if necessary. Operators should pay careful attention to the signs and follow the instructions from the signalman. Only one signalman should give signals. Make sure that all workers understand the meaning of all signals and signs before starting work. PC200LC-8 1-19