OPERATION Working Mode Monitor This monitor (5) displays the setting of the working mode. The monitor display is as follows according to the operation of the working mode switch. P: P mode (for heavy-load operations) E: E mode (for operations with emphasis on fuel consumption) L: L mode (for fine control operations) B: B mode (for breaker operations) ATT: ATT mode (for crusher operations) For details of the positions of the working mode switch, See “CON- TROLS AND GAUGES” on page 2-3. Travel Speed Monitor This monitor (6) shows the setting for the travel speed. The monitor display is as follows according to the operation of the travel speed selector switch. Lo: Low-speed travel Mi:
Mid-range speed travel Hi: High-speed travel For details of the positions of the travel speed selector switch, See “CONTROLS AND GAUGES” on page 2-3. One-Touch Power Max. Monitor This monitor (7) shows if the one-touch power max. function is being actuated. The monitor display when the knob switch on the left control lever is operated is as follows. (The actual monitor display is shown at the position of preheating monitor (1).) Monitor lights up: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Digging power is increased while knob switch is kept pressed. Monitor goes out: . . . . . . . . . . . . . . .
Power max function stopped For details of the positions of the knob switch, See “CONTROLS AND GAUGES” on page 2-3. Remark Only when the working mode is P or E mode, the power is increased while the knob switch is being pressed. Even if the knob switch continues to be pressed, the power increase is finished after 8.5 seconds. 2-20 PC200LC-8