OPERATION Travel Speed Selector Switch When loading or unloading from a trailer, always travel at low speed (with travel speed selector switch (3) at the Lo position). Never operate travel speed selector switch (3) while loading or unloading. If the travel speed is switched between Hi and Lo when the machine is traveling, the machine may deviate to one side, even when traveling in a straight line. Stop the machine before switching the travel speed. Switch (3) is used to set the travel speed to three stages. Lo lights up: Low-speed travel Mi lights up: Medium-speed travel Hi lights up: Hi-speed travel When the engine is started, the speed is automatically set to Lo.
Each time that the switch is pressed, the display changes Lo Mi Hi Lo in turn. Even if the travel speed is set to high-speed (Hi) or a mid-range speed (Mi), when traveling on soft ground or uphill, and travel power is needed, the system automatically shifts down to low speed travel (Lo). There is no need to operate the switch. In this case, the pilot monitor on the monitor display stays lit at Hi (high-speed) or Mi (mid-range speed). Remark Each time travel speed selector switch (3) is switched, the mode is displayed on the monitor display, and after two seconds, the screen returns to the normal operation screen. 2-30 PC200LC-8