INTRODUCTION SECTION 1 Page 5 SERIAL NUMBERS The product identification number (P.I.N.) is stamped on the plate attached to the front wall of the control console at the left hand side of the operator’s seat (Fig. 1.2) or on a plate attached to the filters cover at the left hand side of the machine. It is also stamped on the rear frame in the upper right hand corner under the fender (Fig. 1.3). Fig. 1.3.Product Identification Number (P.I.N.) on RMF Fig. 1.4. Serial Number Designation of Blade. The equipment model designation is stamped on the back of the blade or stamped on the plate attached in this same place, near the top right hand corner (Fig. 1.4). DRESSTA TD-15H