Kohler Command Pro EFI / Aegis ELH775 — Kohler Command Pro EFI & Aegis ELH775 Troubleshooting Guide PDF (EN)

DELPHI EFI Function Test Fault Codes Example of Diagnostic Display (0) One second pause (1) Fault Code 0107 One second pause (0) )XQFWLRQRIIXHOV\VWHPLVWRSURYLGHVXIїFLHQWGHOLYHU\ of fuel at system operating pressure of 39 psi ± 3. If an engine starts hard, or turns over but will not start, it may indicate a problem with EFI fuel system. A quick test will verify if system is operating. 1. Disconnect and ground spark plug leads. 2. Complete all safety interlock requirements and crank engine for approximately 3 seconds. 3. Remove spark plugs and check for fuel at tips. a. If there is fuel at tips of spark plugs fuel pump and injectors are operating. b.

If there is no fuel at tips of spark plugs, check following: 1. Make sure fuel tank contains clean, fresh, proper fuel. 2. Make sure that vent in fuel tank is open. 3. Make sure fuel tank valve (if equipped) is fully opened. 4. Make sure battery is supplying proper voltage. 5. Check that fuses are good, and that no electrical or fuel line connections are damaged or broken. 6. Test fuel pump module operation as described earlier under Fuel Pump. One second pause (7) Three second pause (6) One second pause End Code 61 (1) Diagnostic Fault Code Summary Fault Code Connection or Failure Description 39 24 690 01 Rev.

D KohlerEngines.com WARNING High Pressure Fluids can puncture skin and cause severe injury or death. Do not work on fuel system without proper training or safety equipment. Fluid puncture injuries are highly toxic and hazardous. If an injury occurs, seek immediate medical attention.

0031 Oxygen Sensor Heater Circuit High Voltage 0032 Oxygen Sensor Heater Circuit Low Voltage 0107 Manifold Absolute Pressure Sensor Circuit Low Voltage or Open 0108 Manifold Absolute Pressure Sensor Circuit High Voltage 0112 Intake Air Temperature Sensor Circuit Low Voltage 0113 Intake Air Temperature Sensor Circuit High Voltage or Open 0117 Coolant/Oil Temperature Sensor Circuit Low Voltage 0118 Coolant/Oil Temperature Sensor Circuit High Voltage or Open 0122 Throttle Position Sensor Circuit Low Voltage or Open 0123 Throttle Position Sensor Circuit High Voltage 0131 Oxygen Sensor 1 Circuit Low Voltage, or Open 0132 Oxygen Sensor 1 Circuit High Voltage 0171 Maximum Adaptation Limit Exceeded 0172 Minimum Adaptation Limit Exceeded 0174 Lean Fuel Condition at High Load (Open Loop) 0201 Injector 1 Circuit Malfunction 0202 Injector 2 Circuit Malfunction