4 EBU17910 Coolant temperature warning light “ This warning light comes on when the engine over- heats. When this occurs during operation, stop the engine as soon as it is safe to do so and allow it to cool down for about 10 minutes. The electrical circuit of the warning light can be checked according to the following procedure. 1. Set the engine stop switch to “ ” and turn the key to “ON”. 2. Shift the drive select lever into the neutral po- sition or park position. 3. Push the start switch. If the warning light does not come on while the start switch is pushed, have a Yamaha dealer check the electrical cir- cuit. G The engine may overheat if the ATV is over- loaded.
In this case, reduce the load to spec- ification. G Start the engine after making sure that the warning light is out. Continuous use while the warning light is on may cause damage to CAUTION: the engine. ECB00010 4-2 EBU17830 Reverse indicator light “ This indicator light comes on when the transmis- sion is in the reverse position. EBU17860 Neutral indicator light “ This indicator light comes on when the transmis- sion is in the neutral position. EBU17812 Indicator lights and warning light 1. Neutral indicator light “N” 2. Reverse indicator light “R” 3. Coolant temperature warning light “ 4. Park indicator light “P” 5. On-Command four-wheel-drive indicator light “